Configuration Software and Utilities
83
To use the Server
Configuration utility to
Description of procedure Page
Configure the server for
remote LAN
management
Enable a connection to the server from a workstation on the LAN to
allow remote management functions, such as powering the server on or
off, or running diagnostic utilities.
92
Configure for Remote
Serial / Modem
management
Enable a connection to the server from a serial or Modem connection to
allow remote management functions, such as powering the server on or
off, or running diagnostic utilities.
93
Configure for Serial /
Modem alerting
Configure the server to send a telephone page in the event that a
hardware or firmware error occurs at the server.
96
Configure for LAN
alerting
Configure the server to send a notification message to a workstation
segment of the network in the event that a hardware or firmware error
occurs at the server.
97
Run the FRU/SDR Load
Utility
Use to update the Field Replaceable Unit (FRU) and Sensor Data
Record (SDR) flash components.
NOTE: You must run the FRU/SDR Load utility whenever the BMC is
updated or if you change your processors.
100
Configure an Asset Tag Assign an identification number or serial number to the server 104
Create / modify the
service partition
If a service partition does not already exist, create one. If a service
partition has been created earlier, update it.
105
Create System or Utility
/ Device Diskettes
Create diskettes by operating system, utility, or device driver 104
Save / load
configuration data
Save the configuration data to a file. Use this saved file to configure
other servers identically.
106
To Next Page
Loading...
Need help?
General
