Interlogix Simon XT User Manual

38 Simon XT User Manual
Appendix A: Reference information
This appendix provides a list of system limitations, emergency planning,
floorplan, and a quick reference command table.
Alarm system limitations
Not even the most advanced alarm system can guarantee protection against
burglary, fire, or environmental problems. All alarm systems are subject to
possible compromise or failure-to-warn for a variety of reasons.
• If sirens are not placed within hearing range of persons sleeping, in remote
parts of the premises, or if they are placed behind doors or other obstacles.
• If intruders gain access through unprotected points of entry or areas where
sensors have been bypassed.
• If intruders have the technical means of bypassing, jamming, or disconnecting
all or part of the system.
• If power to sensors is inadequate or disconnected.
• If freeze or any environmental sensors are not located in areas where the
appropriate condition can be detected.
• If smoke does not reach a smoke sensor. For example, smoke sensors
cannot detect smoke in chimneys, walls, roofs, or areas blocked by a closed
door. Sensors may not detect smoke in other levels of the building. Sensors
may not warn in time when fires are caused by smoking in bed, explosions,
improper storage of flammables, overloaded electrical circuits, or other
hazardous conditions.
• If telephone lines are out of service.
Inadequate maintenance is the most common cause of alarm failure. Therefore,
test your system at least once per week to be sure sensors, sirens, and phone
communication are all working correctly.
Although having an alarm system may make you eligible for reduced insurance
premiums, the system is no substitute for insurance.
WARNING: Security system devices cannot compensate you for loss of life or
property.
Emergency planning
Since an emergency is always unexpected, you should develop plans to help
prepare for a variety of emergency situations. Periodically discuss and rehearse
emergency plans to include the following:
• Understand how to use your security system.

Interlogix Simon XT Specifications

Power

power requirements	6V nominal
standby current	30mA (10mA in PowerSave Mode)
peak current	1.7 A

Operating Environment

operating temperature	32 to 120°F (0 to 49°C)
storage temperature	-30 to 140°F (-34 to 60°C)
max. relative humidity	90% non-condensing

Dimensions

height	4 1/16 in.
width	1 7/8 in.