ITech IT6532D User Manual

Calibration Command
Copyright© Itech Electronics Co., Ltd. 100
Arguments
P0|P1
Example
CAL:PROG:VOLT:LEV P0
CALibrate:PROGram:VOLTage[:DATA]
This command is used to set calibration data of program voltage.
Command syntax
CALibrate:PROGram:VOLTage[:DATA] <NRf>
Arguments
NRf
Unit
V
Example
CAL:PROG:VOLT 24.0V
CALibrate:PROGram:CURRent:LEVel
This command is used to set calibration point of program current.
Command syntax
CALibrate:PROGram:CURRent:LEVel <P0|P1>
Arguments
P0|P1
Example
CAL:PROG:CURR:LEV P0
CALibrate:PROGram:CURRent[:DATA]
This command is used to set calibration data of program current.
Command syntax
CALibrate:PROGram:CURRent[:DATA] <NRf>
Arguments
NRf
Unit
A

ITech IT6532D Specifications

General

Brand	ITech
Model	IT6532D
Category	Power Supply
Language	English