ITech IT6532D User Manual

IEEE-488 Commands
Copyright© Itech Electronics Co., Ltd. 112
Returns
<NR1>
*PSC
This command is used to control whether the power supply will generate a
service request when power on again.
 1 OR ON: When the power supply power on, status byte enable register,
operater event enable register, query event enable register and standard
event enable register will be cleared.
 0 OR OFF: When the power supply power on, The value of status byte
enable register, operater event enable register, query event enable register
and standard event enable register will be stored in the none-volatile
storage, which will be recalled when power on.
Command Syntax
*PSC <bool>
Parameters
0|1|ON|OFF
Query Syntax
*PSC？
Returned Parameters
0|1
*RST
This command reset the power supply to default settings.
Command syntax
*RST
Arguments
None
*SRE <n>
This command can set the parameter of state byte enable register.
Setting parameter can determine which byte value of state byte register
is 1 and the byte will set RQS of state byte register to 1. Bit definition of
state byte enable register is as the same as the state byte register.
Command syntax
*SRE <NRf>
Arguments
0～255

ITech IT6532D Specifications

General

Brand	ITech
Model	IT6532D
Category	Power Supply
Language	English

Summary

Warranty

Safety Notices

Safety Precautions

Chapter 1: SCPI Command Introduction

SCPI Overview

Introduces SCPI and its basic structure.

SCPI Command Types

Explains common and subsystem commands.

SCPI Command Messaging and Case Sensitivity

SCPI Message Types

SCPI Command Execution and Response Data Types

SCPI Command Format Syntax

SCPI Data Types

Chapter 2: SCPI Status Register

Status Register Overview

Chapter 3: SCPI Command Description

STATus:QUEStionable Commands

Commands for managing the Questionable status register.

STATus:OPERation Commands

Commands for managing the Operation status register.

SYSTem Commands for Instrument Control

Chapter 4: Display Related Commands

Chapter 5: Trigger Command

Chapter 6: Input Measuring Commands

Voltage and Current Measurement

Commands to measure or fetch DC voltage and current.

Power Measurement

Commands to measure or fetch output power.

Chapter 7: Output Commands

Output Current Control

Commands to set and control output current levels, including min/max and protection.

Output Voltage Control

Commands to set and control output voltage levels, including min/max and protection.

Output Protection and Delay Settings

Output Power Level Control

Output Application and External Control

Output Priority and Filter Settings

Chapter 9: Load Related Command (IT6500C)

Load State and Selection Management

Load Current Parameter Settings

Load Protection Parameter Settings

Load Power Parameter Settings

Chapter 10: List Operation Commands

Chapter 11: Wave Operation Command

Chapter 13: Battery Charge and Discharge Statistic Command

Chapter 14: Calibration Command

Calibration State and Voltage Settings

Commands to set calibration state and define voltage calibration points.

Current and Monitoring Calibration

Programming and Equalization Calibration

Summary Calibration and Save/Initialize

Chapter 15: Parallel Related Command

Chapter 16: Trace Related Command (IT6500C)

Chapter 17: IEEE-488 Commands

Basic IEEE-488 Commands

Service Request and Setup Management