Quick Start
Copyright © Itech Electronic Co., Ltd. 16
2. RS232 Communication interface
3. USB Communication interface
4. GPIB Communication interface (Only for IT6700(G) series)
5. factory using terminal
6. Fuse
7. AC power socket
8. Remote sense terminal and the output terminal
NOTE
Above the output terminals in the rear panel of IT6726B/IT6726G/IT6726H/IT6726V has
a factory using terminal, which users cannot use.
⚫ Rear panel of IT6726C
1. Cooling fans
2. RS232 Communication interface
3. USB Communication interface
4. GPIB Communication interface (Only for IT6700(G) series)
5. RS485 Communication interface
6. Fuse
7. AC power socket
8. the output terminal
9. Remote sense terminal
2.6 Power-on selftest
A successful selftest indicates that the purchased power product meets delivery
standards and is available for normal usage.
Before operation, please confirm that you have fully understood the safety
instructions.
⚫ To avoid burning out, be sure to confirm that power voltage matches with
supply voltage.
⚫ Be sure to connect the main power socket to the power outlet of protective
grounding. Do not use terminal board without protective grounding. Before
operation, be sure that the power supply is well grounded.
⚫ To avoid burning out, pay attention to marks of positive and negative
polarities before wiring.
Selftest steps
Normal selftest procedures:
1. Correctly connect the power cord. Press Power key to start up.
To Next Page
Loading...
Need help?
General
