Acceptance and Installation
Copyright ©ITECH Electronic Co., Ltd. 19
Operation steps
1. Unscrew the screws of the output terminals and connect the red and
black test lines to the output terminals. Re-tighten the screws.
When maximum current that one test line can withstand fails to meet
the current rated current, use several pieces of red and black test lines.
For example, the maximum current is 1,200A, then 4 pieces of 360A
red and black lines are required.
2. Directly connect the other end of the red and black lines to the DUT
terminal.
ООО "Техэнком" Контрольно-измерительные приборы и оборудование www.tehencom.com
To Next Page
Loading...
Need help?
General
