To Next Page

To Previous Page

List Function

Run List file

The user can run power the created List file as needed to enable outputting of

corresponding waveform sequence by the power supply. Detailed operation

steps are as below:

1. Press [On] on the front panel. The power supply will start running once the

trigger signal is received, according to the selected trigger mode. “Running”

will appear in the right lower corner of the interface, as shown in the figure

below.

2. Press [Scope] to display the wave.

Set trigger source

IT7600 series has four trigger source to choose: trigger by keys

(Key),Software trigger (Software),Bus trigger (Bus) and External signal trigger

(External).(refer to 3.15Trigger Function for more details).You can select trigger

source according to various test requirements

8.2 Setting of Surge/trapped Configuration

IT7600 provides surge/trap simulation. The user can add surge/trap to simulate

abnormal voltage fluctuation on the basis of outputting Sin wave, and test

usage of the DUT under this circumstance.

Operating steps

1. Press [List] on the front panel to enter the List function configuration interface.

Press [Surge-Trap] in the List interface to enter the surge/trap parameter

setup interface, as shown in the figure below.

ООО "Техэнком" Контрольно-измерительные приборы и оборудование www.tehencom.com

ITech IT7622 User Manual

Other manuals for ITech IT7622