To Next Page

To Previous Page

List Function

Chapter8 Configuration of Any Waveform

This chapter will introduce configuration of any waveform of IT7600. Besides

the five standard waveforms (see 3.6 Waveform selection) built in the main

interface, the user can enable the outputting of AC wave sequences of different

amplitudes through List and self-define function. Waveform Configuration is not

available for DC and ACDC modes.

8.1 List Function

Under IT7600 List mode, at maximum of 50 steps can be edited for each List

file. The user can choose any waveform from existing 11 waveforms. Or, the

user can choose a waveform file stored in the device through self-define

function (see

8.3 Self-defined Waveform Function for details) and combine the waveform files

into a List file based on required order. Meanwhile, the user can set the starting

steps of the List file, run count and end state of the waveform, and edit

parameters such as frequency, amplitude, running time and rising slope of each

waveform.

Create a new single-phase LIST file

Under single-phase mode, the user can output AC waveform sequences with

different amplitudes by creating a new List file. Detailed operation steps are as

below:

1. Press [List] on the front panel to enter the List function configuration

interface, select soft key [standard]. as shown in the figure below.

Soft Key of

Description

Create New

Create a new List file.

Edit Current

Edit the saved List file.

Recall Config

Recall the saved List file.

Export Config

Export list file

Delete Config

Delete list file

ООО "Техэнком" Контрольно-измерительные приборы и оборудование www.tehencom.com

ITech IT7622 User Manual

Other manuals for ITech IT7622