To Next Page

To Previous Page

List Function

Delete: delete the waveform file.

2. Press [New] and create a new waveform file.

3. Set “Current Index” and “Value” in the waveform file.

X1 X10 X100: multiples of Current Index.

Right: Right move current index, max 1023

Left: Left move current index, min 0

+: increase the current Value, max. 1.0.

-: decrease the current Value, min. -1.0.

4. Press [Save/Edit]

to Save the set waveform file

Import a self-defined waveform file

IT7600 series provide external import function of self-defined waveform file.

The user can finish the editing of List file in Excel and import it into the software.

This function simplifies the List file edit and facilitates user operation.

Detailed operation steps are as below:

1. Create a new Excel document on local PC and name it harWave.

2. Open the Excel document and save it as in “other formats” in “(*.csv)”.

3. Open the harWave csv file and edit the waveform. Set every step of the List

and corresponding parameters (At maximum of 1,024 coordinate points

can be set, and only first 9 coordinate points are displayed below) and save

the file in the USB disk.

4. Insert the USB disk into the USB interface of the front panel. Press [List] on

the front panel to enter the List function configuration interface. Press soft

key [Self-defined Wave Edit].

5. Press soft key [Recall]. Select the harWave csv file. Press [Enter] for

confirmation. This List file will be imported. As shown below.

ООО "Техэнком" Контрольно-измерительные приборы и оборудование www.tehencom.com

ITech IT7622 User Manual

Other manuals for ITech IT7622