Remote Control
Copyright ©ITECH Electronic Co., Ltd. 91
connector.
3. The interface cable is correctly connected (CAN_H to CAN_H, CAN_L to
CAN_L).
Setting Communication
Before communication operation, match the power supply with the following PC
parameters.
Prescale (Pres): Set this parameter as needed
PTS (BS1): Set this parameter as needed
PBS (BS2): Set this parameter as needed
Calculate the Baud Rate according to the above three parameters.
ID (Can ID): Set Can Port ID based on computer.
IDs of other necessary ports (Other1-4 ID): Set IDs of other Can ports as
needed.
ООО "Техэнком" Контрольно-измерительные приборы и оборудование www.tehencom.com
To Next Page
Loading...
Need help?
General
