Basic Operations
Copyright © ITECH Electronic Co., Ltd. 35
5. Press [Enter] to save the setting.
Select one electronic load as the master.
1. Press [Menu] to enter the system menu setting interface.
2. Select [PARALLEL SETUP] to enter the parallel setting interface.
3. Press the Up and Down key to select the “Operating Mode” > “Parallel”.
4. Set “Master/Slave” as Master.
5. Set “Total Slave Unit” as 1, as shown below:
6. Press [Enter] to save the setting.
After saving the settings, the user must power off two electronic loads and
power on again. The interfaces of master and slave are shown as below.
ООО "Техэнком" Контрольно-измерительные приборы и оборудование www.tehencom.com
To Next Page
Loading...
Need help?
General
