To Next Page

To Previous Page

Load Functions

⚫ Iset=1.00A: constant current of CC Mode.

⚫ CF=1.414: crest factor.

⚫ PF=1.000: power factor.

4. Press [Enter] to confirm.

5. Press [On] to enable load input. Loading will be started and the current will

sink.

CF Mode

⚫ Mode setting

The initial default mode of IT8600 electronic load is the “BOTH” mode. CF Mode

can be set as follows:

1. Press [Menu] to enter the system setting interface.

2. Press the soft key corresponding to [SYSTEM SETUP] to enter the system

parameter setting interface.

3. Press the Up and Down key and select the “CF/PF Setting”. Press the soft

key corresponding to [CF] on the right side, and set the present CF/PF

parameter as “CF” mode.

4. Press [Esc] to exit or [Home] to go back to the main interface of CC Mode.

“CF-ONLY” will appear on the main interface.

⚫ CC parameter setting

The user can press the Up and Down key in the main interface of CC Mode to

select the parameter to be set, including CF and Iset. The user can also rotate

the knob to set the current value or press numeric keys to input the set value.

The CF range is 1.414 to 5.000.

1. Press [Set] to enter the parameter setting interface of CC Mode.

2. Press the Up and Down key to select the parameter to be set.

3. Directly set the present value through the knob or press numeric keys to

input the value. In case of wrong input by numeric keys, press to

delete the present input.

ООО "Техэнком" Контрольно-измерительные приборы и оборудование www.tehencom.com

ITech IT8625 User Manual

Other manuals for ITech IT8625