en-21
ADJUSTMENTS 4
4.8 GENERAL INSTRUCTIONS FOR GRAMMER SEATS _______________________
To identify seat type, slide seat forward on its runners to reveal seat label.
All The seat adjustments are to be done while the vehicle is stopped.
• After removal of the backrest cover, hold the backrest frame in position with a support before the backrest
adjuster is operated. If you do not lock the frame in position safely, the backrest frame can move forward
suddenly and can cause injury.
• Use approved GRAMMER parts.
• Only GRAMMAR approved changes are to be made to the seat. During the removal and installation of the
GRAMMER driver seat, follow the instructions supplied by the vehicle manufacturer.
• When you lift the driver seat, do not hold the covers. The covers are not a load bearing component and injury
can occur.
• Before you remove the driver seat, disconnect all plug-in connectors between the seat and the vehicle supply
network. When you replace the plug-in connectors, make sure the connectors are tight so that dust and water
does not enter.
• Fasten seat belts before operation.
• Replace the seat belt after an accident.
• After an accident with a vehicle that has seat belts installed, have the seat and seat mounting checked by
the safety personnel.
• Check the seat fasteners to make sure that the seat is installed correctly.
• If the seat does not operate correctly, have the seat repaired in a GRAMMER workshop. Check the seat for
damage to the seat suspension and bellows or for an incorrect curve in the lumbar support.
• If you do not correct problems that occur in the seat, the seat can damage your health and increase the risk of
an accident.
• Before the vehicle is used, check the load sensor, installed in the seat, for correct operation. If the driver
leaves the seat, this sensor stops the vehicle.
• If a problem is found, you must not drive the vehicle. – INCREASED RISK OF ACCIDENT –
• Do not put the loads on to seats that have a load sensor. A load on the seat can cause the vehicle to move
and cause an accident. – INCREASED RISK OF ACCIDENT –
• If you drive the vehicle and remove the weight from the seat, the vehicle will stop.
• Do not load the bellows while there is a load on the driver seat. – RISK OF INJURY FROM BELLOWS –
• Make sure that dirt and liquids can not get inside the drivers seat.
• The driver seat is not waterproof.
• Any changes or adjustment to a GRAMMER driver seat must be done in authorised workshops by approved
personnel. The changes must follow the operation instructions and must be in compliance with all national
regulations.
• Incorrect installation and assembly hold the risk of personal injury or property damage. Your warranty will also
be invalidated.
To Next Page
Loading...
Need help?
General
