45
QAddition of chemcial additives at first start-up
Please refer to the Jacuzzi system water treatment guide and
relative catalogue for details on water quality maintenance, the
methods and warnings governing the use of relative chemical
products.
ATTENTION: read and follow all the instructions related to
the use and storage methods of chemical products, in strict
compliance with the manufacturer’s instructions provided
on the packaging.
ATTENTION! Do not use trichlorine tablets! This can dam-
age the components of the hot tub and cause burning and
irritation to the skin and mucous membranes. The use of
these chemicals will void the manufacturer’s warranty.
WARNING!
Do not get in the spa until the quantity of disinfectant has not
dropped below the level recommended by the manufacturer
and/or by your retailer.
Leave spa cover open to allow excessive chemical vapors to
exit spa, protecting pillows and plastic knobs from chemical
attack. If spa is indoors, open doors and windows for proper
ventilation.
QSet Spa To Heat
To warm spa water to a comfortable temperature, follow these
steps:
The display on the control panel displays the actual temper-
ature of the spa water. Tap (
) or ( ) to increase or de-
crease the water temperature in 0,5 °C increments.
The heater will turn off 0,5 °C degree above set temperature
and turn on 1 °C below set temperature.
Note: The temperature range for the spa is 18.33°C to 40°C (65
to 104°F). To activate the Extended Temperature feature that
allows the spa to reach 41°C ( 106°F) see chapter “Extended
Temperature Activated”.
The maximum temperature for which the spa can be set is 40°C
(104°F) and the minimum is 18.33°C (65°F).
Setting the thermostat at maximum will not accelerate the
heating process. This will only result in a higher ultimate tem-
perature.
Keeping the insulating cover in place anytime the spa is not
in use will reduce the time required for heating, thereby min-
imizing operating costs.
The time required for initial heat-up will vary depending on the
starting water temperature.
10
9
10
6
2
3
1
5
11
11
12
7
15
14
4
13
8
1 Control Panel
2 Control Box
3 Heater
4 Filter/Circulation Pump
5 Jets Pump
6 Jets Pump
7 CLEARRAY Water Purification System
8 CLEARRAY power unit
9 QuickDrain™
10 Pump Drain Plugs(s)
11 Power Supply Entrance(s)
12 Spa Drain Valve
13 BLUEWAVE 2.0 Wireless Stereo (Optional)
14-15 SmartTub™ System (Optional)
Note: the position and number of the components varies from model to model.
To Next Page
Loading...
Need help?
General
