4-2-2 Keyboard
1) 0 ~9 numeric keys Enter specific values for tare; unit weight and other data entries.
2) ● key Decimal point
3) SMPL key Short press to enter the sampling mode. Long press to close ACAI
after sampling. And shift Units when setting capacity.
4) G N/SET key Shift the displays of Gross weight and Net weight after tare. Long press to
enter parameters setting. And turn on or turn off check weighing when entering HI, LO, OK
setting.
5) UWS/ITEM key Find out the unit weight in memory or reset the unit weight again. Input
the indicated unit weight via numeric keys and press it to start counting function.
6) M+/SAVE key Accumulate the records of counting or weighing. Save the changing
parameter. Set the capacity and resolution.
7) M-/HI key Clear the input figures. Set the value of HI. Enable the blinking figure plus
one when inputting the figures.
8) ZERO/ESC key Zero the display (within 2% of max.capacity) or cancel Tare action.
Exit from the setting without saving.
9)
/MR key Recall and display the total Accumulation data (weight, total count and
number of weightments ) and the first 10 records in details. Circle the choices in the
setting. Make the blinking spot shift leftwards when inputting the figures.
10) PRINT/LO key Press the key to print when printing manually is selected. Set the LO
value. Enable the blinking figure decrease one when inputting the figures.
11) TARE/
key Input the weight of the object on the weighing pan as a Tare value ; Inputs
the indicated value entered via the numeric keys as a pre-set Tare value ; cancel tare
action. Display rightwards the first 10 records in detail. Make the blinking spot shift
rightwards when inputting the figures.
To Next Page
Loading...
Need help?
General
