JBL PSW-D110 User Manual

TROUBLESHOOTING
If you used the high-level (speaker) inputs and there is no
sound from any of the speakers, check the following:
• Receiver/amplifier is on and a source is playing.
• Powered subwoofer is plugged in.
• Check all wires and connections between
receiver/amplifier and speakers. Make sure all wires are
connected. Make sure none of the speaker wires are frayed,
cut or punctured.
• Review proper operation of your receiver/amplifier. If there
is low bass output, check the following:
• Make sure the connections to the left and right “Speaker
Inputs” have the correct polarity (+ and –).
• Make sure that the sub-woofer is plugged into an active
electrical outlet.
• Powered subwoofer is plugged in.
• Adjust the crossover point.
If you used the line-level inputs and there is no sound from
the subwoofer, check the following:
• Receiver/amplifier is on and a source is playing.
• Powered subwoofer is plugged in.
• Check all wires and connections between receiver/
amplifier and subwoofer. Make sure all wires are connected.
Make sure none of the wires are frayed, cut or punctured.
• Review proper operation of your receiver/amplifier.
9
Amplifier/Subwoofer PSW-D110/DPS-10

JBL PSW-D110 Specifications

Power

power output (RMS)	150 watts

Driver

driver size	10"
driver material	High-Polymer Laminate

Inputs and Outputs

inputs	Line Level and Speaker Level
outputs	Line Level and Speaker Level

Frequency

frequency range	60Hz – 180Hz
frequency response	30Hz – low-pass crossover setting

Weight and Dimensions

dimensions	15-3/8 x 15-3/8 x 17" / 391 x 391 x 432mm
weight	33 lbs / 15 kg