Operation
Starting the Engine
106 106
9811/9950-1
Immobiliser
There are two different JCB immobiliser systems, one uses
a keypad and the other a unique key system.
Note: If your machine has an immobiliser system installed,
then your JCB dealer should enable the system as part of
the standard machine installation.
Keypad Immobiliser System
T2-028_5
To Disarm the Immobiliser
Note: You have three attempts to disarm the system, the
forth attempt will lock the system for 30 minutes. It then
resets and you will have three more attempts.
Note: If you wait more than eight seconds between button
presses, then the immobiliser will go into error mode.
1 Put the starter key in the starter switch.
2 Push the MD button, then enter your four-digit PIN
number. The LED A flashes when you push a button.
3 Push the ENT button.
The LED A flashes twice when you enter an incorrect
PIN number. You must complete step 2 again.
The LED A comes ON for three seconds after you
enter a correct PIN number. Continue to step 4.
4 Start the engine as shown in Starting the Engine.
To Next Page
Loading...
Need help?
General
