jcb 8025 ZTS User Manual

Operation
Storage of the Machine
157 157
9811/9950-1
4 Fill the fuel tank to prevent a build up of condensation
in the tank.
5 Examine the coolant condition. Replace if necessary.
6 Examine all fluid levels. Top up if necessary.
Put the Machine into Storage
T2-077
1 Park the machine on level, solid ground.
Park the machine in a position where the machine is
easy to get access (in case the machine does not
start at the end of the storage period).
Place suitable timbers under the machine to eliminate
direct contact with the ground.
2 Retract all rams and lower the attachments to the
ground.
3 Vent the hydraulic system.
4 Remove the starter key.
5 Apply a thin layer of grease or petroleum jelly to all
exposed ram piston rods.
6 Remove the battery. Charge the battery.
Keep the battery in warm, dry conditions. Charge the
battery periodically.
7 If you keep the machine outdoors, cover the machine
with tarpaulins or plastic sheets.
During Storage
T2-078
Operate the machine functions each week to prevent a
build up of rust in the engine and hydraulic circuits, and to
minimise deterioration of the hydraulic seals.
HE Services

jcb 8025 ZTS Specifications

General

Brand	jcb
Model	8025 ZTS
Category	Excavators
Language	English

Summary

Safety Notices

Important Information

General advice on handling the operator manual and its importance.

Safety Warnings

Explains the meaning of safety signal words like Danger, Warning, Caution.

Introduction

About this Manual

Information about the manual's purpose, scope, and how it's structured.

Machine Model and Serial Number

Details on identifying machine models and serial numbers.

Component Location

Identifies key components of the machine with numerical labels and diagrams.

Safety Check List

Pre-Operation Safety

Covers safety checks and general safety practices before operating the machine.

Operational Hazards and Precautions

Details risks like machine condition, limits, failures, environment, work sites, and specific hazards.

Maintenance Safety

General Maintenance Safety

Covers safety during repairs, electrical circuits, fluids, and fuel system handling.

Battery and Chemical Safety

Safety precautions related to batteries, acids, cleaning agents, and hazardous materials.

Safety Labels

Safety Label Identification

Illustrates and identifies various safety labels used on the machine.

Label Descriptions

Provides part numbers and descriptions for specific safety labels.

Identifying Your Machine

Machine Identification Plate

Details about the machine's identification plate and its information.

Product and Engine Identification

Explanation of PIN, serial numbers, and component identification plates.

ROPS, TOPS and FOGS

Safety regarding ROPS, TOPS, and FOGS structures.