Routine Maintenance
Cleaning the Machine
195 195
9811/9950-1
!MCAUTION
The engine or certain components could be damaged
by high pressure washing systems; special
precautions must be taken if the engine is to be
washed using a high pressure system.
Ensure that the alternator, starter motor and any other
electrical components are shielded and not directly
cleaned by the high pressure cleaning system.
ENG-3-3
Important: Do not aim the water jet directly at bearings, oil
seals or electrical and electronic components such as the
engine electronic control unit (ECU), alternator or fuel
injectors.
Use a low pressure water jet and brush to soak off caked
mud or dirt.
Use a pressure washer to remove soft dirt and oil.
Note: The machine must always be greased after
pressure washing or steam cleaning.
Preparing the Machine for Cleaning
P11-3004
1 Make the machine safe with the excavator lowered.
Refer to Prepare the Machine for Maintenance.
Important: Stop the engine and allow it to cool for at least
one hour. Do not attempt to clean any part of the engine
while it is running.
2 Make sure that all electrical connectors are correctly
coupled. If connectors are open fit the correct caps or
seal with water proof tape.
To Next Page
Loading...
Need help?
General
