Jonsered GC 2225 User Manual

ASSEMBLY
12 – English
Fitting the trimmer guard and
trimmer head
• Fit the correct trimmer guard (A) for use with the
trimmer head. Hook the trimmer guard/combination
guard onto the fitting on the shaft and secure with the
bolt (L).
• Fit the drive disc (B) on the output shaft.
• Turn the output shaft until one of the holes in the drive
disc aligns with the corresponding hole in the gear
housing.
• Insert the locking pin (C) in the hole to lock the shaft.
• Screw on the trimmer head/plastic blades (H) in the
opposite direction to the direction of rotation.
• To dismantle, follow the instructions in the reverse
order.
Assembling and dismantling the
two-piece shaft
(GC2225C)
Assembly
• Loosen the coupling by turning the knob.
• Align the tab of the attachment (A) with the arrow on
the coupling (B).
• Push the attachment into the coupling until the
attachment snaps into place.
• Before using the unit, tighten the knob securely.
Dismantling
• Loosen the coupling by turning the knob (at least 3
times).
Push and hold the button (C). While securely holding the
engine end, pull the attachment straight out of the
coupling.
A
A
B
C
H
H
A
B
C
J1156233-38,GC2225,C_1.fm Page 12 Friday, December 6, 2013 7:26 AM

Jonsered GC 2225 Specifications

General

Brand	Jonsered
Model	GC 2225
Category	Trimmer
Language	English