16
It is impossible to perform stitch-
ing if the needle is not correctly
installed or a bent needle is used.
Pay close attention as this will
cause machine malfunction.
Note
:
* Use the needle: No.11-16 and
the thread: No.30-90.
* When twin needle is used, the
automatic needle threader
can not be used.
Needle thread preparation
Make sure
to push
the needle
to the top.
1
2
3
4
5
6
Warning
Turn OFF the power switch before winding the bobbin thread.
Lift the presser foot lifting lever.
Place a thread spool to the spool pin and a spool
cap onto the spool pin.
①
②
Small spool
Spool Cap
Large spool
Spool Cap
1
2
3
4
5
Thread to guide
1
.
Hold the thread end and thread according to the
arrow marking.
*
Make sure that the presser foot is raised. Otherwise
the machine is not correctly threaded.
* Check that the thread take-up is correctly threaded.
③
6
Thread the guide
6
from the right-hand side.
④
*
Align the marking
at the hand wheel
with the one on the
machine body.
Threading the needle thread
To Next Page
Loading...
Need help?
General
