Operation manualⅠ
2− 1
Chapter 2 Operation Procedure
2.1 Flow of PWB production
The following flow chart indicates the operation flow from power-on to the end of PWB
production.
To perform a routine PWB production, follow the operations in order: No. 1, No.2, No.
3, No. 4, No. 9, No. 10, No. 11 and No. 12.
No Flow chart
Person who
operates the
machine
Comment
1
Perform this operation only after you
perform inspections such as checking
of the main air pressure (0.5 Mpa) and
checking to see if there is no foreign
substance around the ATC.
2
Check to see if there is no foreign
substance inside the machine before
production.
3
Be sure to warm up the system after
holidays or in cold climates (it takes
approximately 10 minutes).
4
Operator
When you change a PWB type to be
produced, you have to adjust the
conveyor to the size of the PWB.
5
When the initial setup conditions of the
machine change due to cleaning of the
nozzle or change of the reference pin
position, set the “Machine setup” items
again. (Refer to Section 4.4 “Machine
setup” of the “Operation Manual II.”)
6
Refer to Section 4.1 “Database” of the
“Operation Manual II.”
7
8
Programmer
Administrator
If any problem occurs during PWB
placement:
for example, the PWB position is shifted
from the regulated position or the
centering function fails, correct the
production program on the “Program
Editor” menu. You can correct a part of
component data on the “Production”
menu also.
9
10
11
12
Operator
Refer to Chapter 5 “Daily maintenance”
of the “Operation Manual II.”
Power ON
Warm-up
PWB setting
Production
End of production
Power OFF
PWB placement
confirmation
No
roblem
Daily inspection
Correct the
program.
Problem
Yes
Origin return
Creation/Edition of your production program
Change the machine
setup conditions?
No
Create the component
database?
Yes
No
Change the desired
settings on the Machine
setup menu.
Create component data
on the “Database” menu.
To Next Page
Loading...
Need help?
General
