−
8
−
It slowly flashes on and off : When a failure of operation occurs. (Refer to “Alarm No.
indication”.)
(Note) ItashesonandoffeveninastatethatthesewingLEDonthesewingmachine
operationboxgoesout.
It quickly ashes on and off : When the button sensor on the index unit continuously detects
button feeding failure over 10 times.
Used to manually actuate the series of operations under respective operation modes (“2.
Independent sewing mode” is excluded.) which can be selected using mode selector switch
.
Alarmindicatorlamp(red)
MANUALoperationswitch
3.Operationofthebuttonfeederunit
(1) Explanationofthebuttonfeederunitcontrolpanel
Function
Lights up when the power switch is turned ON. If it fails to light up, check the power plug for
secure connection and re-turn ON the power switch.
Symbolandnameofswitch
Powerindicatorlamp(green)
Partsfeedercontroller(ForEurope)
Inspectionswitch
Normally, this switch does not function.
It is used to inspect the drive source and the sensors.
To Next Page
Loading...
Need help?
General
