– 25 –
ENGLISH
6. Setting of functions of SC-922
Functions can be selected and specied.
(Caution) For the function setting procedure of any operation panel other than CP-18, refer to the In-
struction Manual for the operation panel to be used.
1) Turn ON the power with
switch
7
held pressed.
(The item which has been changed
during the previous work is dis-
played.)
* If the screen display does not
change, re-carry out operation de-
scribed in step 1).
(Caution) Be sure to re-turn ON the
power switch when one or more
seconds have passed after turn-
ing it OFF. If the power switch is
re-turned ON immediately after
turning it OFF, the sewing ma-
chine may fail to operate normally.
In such a case, be sure to turn ON
the power switch again properly.
2) To move the setting No. forward,
press switch
4
. To move the
setting No. backward, press
switch
3
.
(Caution) If the setting No. is moved
forward (or backward), the previ-
ous (or subsequent) content of
thesettingisconrmed.Becare-
ful when the content of a setting
is changed (when the
/
switch is touched).
Example) Changing the maximum num-
ber of revolutions (setting No. 96)
Press switch
3
or switch
4
to call setting No. "96."
The current set value is displayed
on indicator
B
.
Press switch
5
to change the
set value to "2500".
* The content of setting of the setting No. returns to the initial value by pressing switch
5
and
switch
6
simultaneously.
3) After completion of the changing procedure, press switch
3
or switch
4
to conrm the up-
dated value.
(Caution) If the power is turned OFF before carrying out this procedure, the changed content is not up-
dated. When switch
3
is pressed, the display on the panel changes to the previous setting
No. When switch
4
is pressed, the display on the panel changes to the subsequent setting
No. After completion of the operation, the machine is returned to the normal sewing state by turn-
ing OFF the power and re-turning it ON.
6
543
7
6
543
7
6
543
7
B
A
D
E
C
B
A
D
E
C
B
A
D
E
C
To Next Page
Loading...
Need help?
General
