KNX Room actuator 230 V
Ref.-no.: RA 23024 REGHE
1 Safety instructions
Electrical equipment must be installed and fitted by qualified
electricians only. Observe the current accident prevention regulations.
Failure to observe the instructions may cause damage to the device
and result in fire or other hazards.
The device is not suited for safe disconnection of the mains supply.
Do not connect consumers for SELV / PELV voltages..
Connect only electro-thermal valve drives to the heating outputs. Do
not connect inductive or capacitive loads.
Do not operate electro-thermal valve drives with DC voltage. Do not
connect three-phase AC motors.
These operating instructions are part of the product and must be left
with the final customer.
2 Device layout
Fig.1: Device layout of room actuator 230 V
(1) keypad for manual control
(2) programming button and LED
(3) KNX connection
(4) mains supply connection
(5) output status LEDs
(6) connecting terminals for consumers / blinds/shutters
(7) connecting terminals for 230 V valve drives
3 Function
3.1 System Information
This device is a product of the KNX system and complies with KNX
directives. Detailed technical knowledge obtained in KNX training courses is
a prerequisite to proper understanding.
The functionality of this device depends on the software.
Detailed information on loadable software and attainable functionality as
well as the software itself can be obtained from the manufacturer‘s product
database.
Planning, installation and commissioning of the unit is effected by means of
KNX-certified software. The full functionality is available with KNX
2
To Next Page
Need help?
General
