•
Ground wires—We recommend a minimum of 18-AWG ground wire for AC and
DC-powered versions, if applicable.
•
Two #10 kep nuts (supplied) to connect the ground (earth) wire to the ground terminal.
•
Power module wiring—We recommend a minimum of 18-AWG wire for the device with
a dual stud terminal lug with 5/8-inch spacing.
Consider the distance from the connection point and the configuration of the device
when determining the size of wire used.
Connect Management Ports
The management section of the CTP2000 series has one port for management access—a
10/100Base-T Ethernet port that accepts an RJ-45 (male) connector, providing an
out-of-band connection for LAN access through an SSH session or SNMP. (See
Figure 5 on page 14 and Figure 6 on page 14 for the console port locations on PP310,
PP332, and PP833 processors.)
The management port is considered a data terminal equipment (DTE) interface. Direct
connection to a terminal or PC (which also has a DTE interface) requires a crossover
cable.
Figure 5: Console Port (COM2) Location on PP310 and PP332 processors
ETH1 USBConsole
Power input and switch
COM2 COM3
PMC I/O 1
PMC I/O 2
Not used Not used
Not used ETH0
g015353
Figure 6: Console Port (RS232) Location on PP833 Processor
g0 0 90 77
PMC/XMC1 PMC/XMC2
2 USB 1 ETH1 ETH2S R U P RS232H
PMC/XMC1 PMC/XMC2
USB1
USB2 ETH1
ETH2
Console
To connect the device to the network:
1. Insert an Ethernet cable (RJ-45) connector into the 10/100Base-T (RJ-45) port until
it clicks into place.
2. Connect the other end of the cable to the appropriate Ethernet network for an
out-of-band connection.
Copyright © 2019, Juniper Networks, Inc.14
CTP2000 Series Platform Quick Start
To Next Page
Loading...
Need help?
General
