WARNING: Three people are required to install the device in a rack: two to
lift the device into position and one to screw it to the rack.
To unpack the device:
1. Cut the two straps that secure the carton to the skid, open the carton from the top,
and remove the box of accessories that sits on top of the device.
2. Unlock the four plastic clips that hold the box to the skid by squeezing them in their
center and pulling out, and then lift the carton off the device.
3. Remove the three screws that attach each of the two L-brackets to the device.
4. To avoid scratching the device when removing it from the skid, detach one of the
L-brackets from the skid by removing the three screws.
Inspect the Components and Accessories
After you remove the equipment from the shipping containers:
•
Confirm the contents of each container.
•
Inspect all external surfaces and external connectors for visible signs of damage.
•
Inspect all accessories shipped with each unit.
•
Document any damage noted during your inspection.
•
Confirm that the device has the correct number and type of modules for your ordered
configuration.
If You Detect or Suspect Damage
If you detect or suspect damage to any equipment:
•
Contact the shipper responsible for delivery, and formally report the damage.
•
Contact your Juniper Networks sales representative or reseller.
Step 2: Install the Platform
•
Before You Begin Installation on page 5
•
Option: Install the Platform in Freestanding Mode on page 5
•
Option: Install the Platform in a Rack on page 5
Copyright © 2019, Juniper Networks, Inc.4
CTP2000 Series Platform Quick Start
To Next Page
Loading...
Need help?
General
