Quick Start Guide
EX Series Redundant Power System
IN THIS GUIDE
Step 1: Begin | 1
Step 2: Up and Running | 4
Step 3: Keep Going | 6
Step 1: Begin
IN THIS SECTION
Mount the RPS | 2
Connect Power to the RPS | 2
To install and configure a Juniper Networks EX Series Redundant Power Supply (RPS), you need:
•
Two mounting brackets and eight mounting screws for rack mounting (provided)
•
One RPS cable per switch (one is provided, six is the maximum needed)
•
At least one EX-PWR3-930-AC power supply (one provided in a separate box)
•
Electrostatic discharge (ESD) grounding strap (not provided)
To Next Page
Need help?
General
