To Next Page

To Previous Page

Figure 96: Crypto Accelerator Module Location on J4350 and J6350 Routers

To modify a Crypto Accelerator Module configuration, use the following procedures:

■ Removing a J4350 or J6350 Crypto Accelerator Module on page 204

■ Installing a J4350 or j6350 Crypto Accelerator Module on page 205

Removing a J4350 or J6350 Crypto Accelerator Module

NOTE: If you are installing a Crypto Accelerator Module into a J4350 Services Router

for the first time, proceed directly to “Installing a J4350 or j6350 Crypto Accelerator

Module” on page 205.

To remove the Crypto Accelerator Module:

1. Place an electrostatic bag or antistatic mat on a flat stable surface to receive the

Crypto Module.

2. Attach an electrostatic discharge (ESD) grounding strap to your bare wrist and

connect the strap to the ESD point on the chassis, or to an outside ESD point if

the router is disconnected from earth ground. For more information about ESD,

see “Preventing Electrostatic Discharge Damage” on page 249.

3. Press and release the power button to power off the Services Router. Wait for

the POWER LED to turn off.

4. Unplug the power cord or cable from the power source receptacle.

5. Remove the screws from the sides and the top of the chassis, and slide the cover

off the chassis.

204 ■ Replacing Crypto Accelerator Modules on J4350 and J6350 Routers

J2320, J2350, J4350, and J6350 Services Router Getting Started Guide

Juniper J-Series Getting Started Guide

Other manuals for Juniper J-Series