save
reset
5. Once the system is booted from the USB storage device, take a snapshot on
the external CompactFlash using the request system snapshot media external
command.
NOTE: Once the snapshot has been taken on the external CompactFlash, we
recommend you to set the ext.cf.pref to 0 at the U-boot prompt.
Security
■
J Series devices do not support the authentication order password radius or
password ldap in the edit access profile profile-name authentication-order command.
Instead, use order radius password or ldap password.
WLAN
■ While configuring the AX411 Access Point on your SRX Series devices, make
sure to enter the WLAN admin password using the set wlan admin-authentication
password command. This command prompts for the password and the password
entered is stored in encrypted form.
NOTE:
■ Without wlan config option enabled, the AX411 Access Points will be managed
with the default password.
■
Changing the wlan admin-authentication password when the wlan subsystem option
is disabled might result in mismanagement of Access Points . You might have
to power cycle the Access Points manually to avoid this issue.
■ The SRX Series devices that are not using the AX411 Access Point can optionally
delete the wlan config option.
■ Accessing the AX411 Access Point through SSH is disabled by default. You can
enable the SSH access using the set wlan access-point <name> external system
services enable-ssh command.
Changes In Default Behavior and Syntax in JUNOS Release 10.1 for SRX Series Services Gateways and J Series Services
Routers ■ 131
Changes In Default Behavior and Syntax in JUNOS Release 10.1 for SRX Series Services Gateways and J Series Services Routers
To Next Page
Loading...
Need help?
General
