MPLS
■ MPLS enhancements—On EX3200 and EX4200 switches, MPLS supports class
of service (CoS), IP over MPLS, and fast reroute to reroute the label-switched
path in cases of link failure.
Packet Filters
■ IPv6 support for firewall filters on EX3200 and EX4200 switches—On EX3200
and EX4200 switches, you can apply match conditions to IPv6 traffic on Layer
3 interfaces, aggregated Ethernet interfaces, and loopback interfaces.
The following are the match conditions applicable to IPv6 traffic:
destination-address, destination-port, destination-prefix-list, icmp-code, icmp-type,
interface, next-header, packet-length, source-address, source-port, source-prefix-list,
tcp-established, tcp-flags, tcp-initial, and traffic-class
The following are the actions and action modifiers applicable to IPv6 traffic:
accept, discard, routing-instance, analyzer, count, forwarding-class, loss-priority, and
policer.
■ Enhancement to the interface match condition on EX8200 switches—On
EX8200 switches, you can now specify aggregated Ethernet interfaces as match
conditions using the interface match condition. You can configure an ingress or
egress firewall filter with an aggregated Ethernet interface as a match condition
and apply the firewall filter to ports, VLANs, and Layer 3 interfaces.
Related Topics ■ Changes in Default Behavior and Syntax in JUNOS Release 10.1 for EX Series
Switches on page 189
■ Limitations in JUNOS Release 10.1 for EX Series Switches on page 190
■ Outstanding Issues in JUNOS Release 10.1 for EX Series Switches on page 193
■ Resolved Issues in JUNOS Release 10.1 for EX Series Switches on page 196
■ Errata in Documentation for JUNOS Release 10.1 for EX Series Switches on
page 199
■ Upgrade and Downgrade Issues for JUNOS Release 10.1 for EX Series Switches
on page 200
Changes in Default Behavior and Syntax in JUNOS Release 10.1 for EX Series Switches
The following changes in system behavior, configuration statement usage, or
operational mode command usage have occurred since the previous release and
might not yet be documented in the JUNOS Software for EX Series switches
documentation:
Changes in Default Behavior and Syntax in JUNOS Release 10.1 for EX Series Switches ■ 189
Changes in Default Behavior and Syntax in JUNOS Release 10.1 for EX Series Switches
To Next Page
Loading...
Need help?
General
