Juniper JUNOS 10.1 - RELEASE NOTES REV 4 User Manual

■ RADIUS interim accounting—When subscriber management receives the
RADIUS Acct-Interim-Interval attribute (attribute 85), RADIUS interim accounting
is performed based on the value in the attribute. The router uses the following
guidelines:
■ Attribute value is within the acceptable range (10 to 1440
minutes)—Accounting is updated at the specified interval.
■ Attribute value of 0—No RADIUS accounting is performed.
■ Attribute value is less than the minimum acceptable value (10
minutes)—Accounting is updated at the minimum interval.
■ Attribute value is greater than the maximum acceptable value (1440
minutes)—Accounting is updated at the maximum interval.
In previous releases, a RADIUS attribute set to zero (0) prevented subscribers
from connecting.
[Subscriber Access]
User Interface and Configuration
■
Restriction on the usage of the annotate command in the configuration
hierarchy—The JUNOS Software supports annotation of the configuration using
the annotate command up to the last level in the configuration hierarchy.
However, annotation of the configuration options or statements within the last
level in the hierarchy is not supported. For example, in the following sample
configuration hierarchy, annotation is supported up to the level 1 parent hierarchy,
but is not supported for the metric child statement:
[edit protocols]
isis {
interface ge-0/0/0.0 {
level 1 metric 10;
}
}
}
[CLI User Guide]
■ Support for accounting is restricted to events and operations on a master
Routing Engine—Starting with JUNOS Release 9.3, accounting for backup Routing
Engine events or operations is not supported on accounting servers such as
TACACS+ or RADIUS. Accounting is only supported for events or operations on
a master Routing Engine.
[CLI User Guide]
■
Options added to the show arp command—The vpn and logical-system options
have been added to the show arp command.
[System Basics Command Reference]
■
Change in range of the saved-core-files configuration statement—The range
of the saved-core-files configuration statement at the [edit system] hierarchy level
has been revised from 1 through 64, to 1 through 10.
Changes in Default Behavior and Syntax in JUNOS Release 10.1 for M Series, MX Series, and T Series Routers ■ 51
Changes in Default Behavior and Syntax in JUNOS Release 10.1 for M Series, MX Series, and T Series Routers

Juniper JUNOS 10.1 - RELEASE NOTES REV 4 Specifications

General

Brand	Juniper
Model	JUNOS 10.1 - RELEASE NOTES REV 4
Category	Software
Language	English