To Next Page

To Previous Page

Step 4: Connect the Grounding Cable

1. Attach an electrostatic discharge (ESD) grounding strap to your bare wrist, and connect

the strap to an approved site ESD grounding point. See the instructions for your site.

2. Connect the grounding cable to a proper earth ground.

3. Verify that a licensed electrician has attached the cable lug provided with the router

to the grounding cable.

4. Make sure that grounding surfaces are clean and brought to a bright finish before

grounding connections are made.

5. Attach an ESD grounding strap to your bare wrist and connect the strap to one of the

ESD points on the chassis.

6. Place the grounding cable lug over the grounding points. The grounding point is sized

for UNC 1/4-20 bolts.

7. Secure the grounding cable lug to the grounding points, first with the washers, then

with the screws.

8. Verify that the grounding cabling is correct, that the grounding cable does not touch

or block access to router components, and that it does not drape where people could

trip on it.

MX480 3D Universal Edge Router Quick Start

Juniper MX480 User Manual

Other manuals for Juniper MX480