15
1 Preparing and using for the first time
You can find out what the water hardness is by using the Aquadur®
test strip supplied as standard.
T Hold the test strip briefly (for 1 second) under flowing water.
Shake off the water.
T Wait for about 1 minute.
T You will then be able to read the degree of water hardness
from the discoloration of the Aquadur® test strip and the
description on the packaging.
Level Display German
Degree (°dH)
Degrees of general
hardness (°dGH)
Parts per
million (ppm)
Indicator Strip number
of ‘reddish’ fields
Not active – – – –
Very soft water <3 <3 < 53.4 None
Soft water > 4 > 4 > 71 1
Hard water > 8.4 > 8.4 > 150 2
Very hard water > 14 > 14 > 250 3
Your GIGA creates fine, creamy, feather-light milk foam with a
perfect consistency. The most important requirement for frothing
milk is a milk temperature of 39–46 °F (4–8 °C). We would therefore
recommend using a milk cooler or a vacuum milk container.
T Connect the milk pipe to the dual spout. To do this, attach
the end of the milk pipe (without the connector) to the con-
nector on the right-hand side of the dual spout. Use the
short pipe for a milk container and the long pipe for a milk
carton.
T Connect the other end of the milk pipe to a milk container
or immerse it in a milk carton.
Determining the water
hardness
Connecting milk
To Next Page
Loading...
Need help?
General
Weight and Dimensions
