54
7 Troubleshooting
7 Troubleshooting
Problem Cause/Result Action
Insufficient foam is
produced when the milk
is frothed, or milk sprays
from the dual spout.
The dual spout is dirty.
T Rinse and clean the dual spout (see
Chapter 5 ‘Maintenance – Cleaning
the milk system’).
Coffee only comes out in
drips when it is being
prepared.
Coffee or ground coffee has
been ground too finely and
is blocking the system. The
same filter cartridge may
have been used several
times or the water hardness
set incorrectly in the
programming mode.
T Put the grinder on a coarser setting
or use coarser ground coffee (see
Chapter 4 ‘Permanent settings in
programming mode – Setting the
consistency of grind’).
T Perform descaling (see Chapter 5
‘Maintenance – Descaling the
machine ’).
‘Fill bean container.’
is not displa
yed although
the bean co
ntainer is
empty.
The bean monitor is dirty.
T Clean the bean container (see
Chapter 5 ‘Maintenance – Cleaning
the bean container’).
Preparation stops,
‘Fill bean container.’
is briefly displa
yed
although the bean
co
ntainer has been filled.
The sliding catch for the
bean container has not been
pulled out or has not been
pulled out completely.
T Open the service cover on the back
of the machine and pull the sliding
catch all the way out (see Chapter 5
‘Maintenance – Cleaning the bean
container’).
‘Empty drip tray.’
is alw
ays display
ed.
The metal contacts of the
drip tray are dirty or wet.
T Clean and dry the metal contacts on
the back of the drip tray.
‘Fill water tank.’
is displa
yed although the
wa
ter tank is full.
The water tank float is
trapped.
T Descale the water tank (see
Chapter 5 ‘Maintenance – Descaling
the water tank’).
‘Error 2’ is displayed. If the machine was exposed
t
o the cold f
or a long period
of time, heating is disabled
for safety reasons.
T Warm the machine at room
temperature.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
