21
2 Preparation
It is easy to make permanent settings for the amounts (amount of
water, amount of milk etc.) for all products according to the cup size.
Adjust the amount once as shown in the following example. Every
time you prepare a drink in the future, this amount of water will be
dispensed.
The permanent settings for adapting the amounts to the cup size
for all products follow this model.
Example: Proceed as follows to permanently set the amount of
water for one coffee.
Precondition: ‘Please select product:’ is displayed.
T
Place a cu
p under the dual spout.
T Press and hold the ‘Coffee’ button.
‘Coffee’ and the fill volume are displayed.
T Hold the ‘Coffee’ button down until ‘Enough coffee? Press
butt
on.’ appear
s.
T Release the ‘Cof
fee’ button.
Preparation start
s and the coffee flows into the cup.
T Press any button as soon as there is sufficient coffee in the
cup.
Preparation stops. ‘Saved’ appears briefly on the display. The
set amount of w
ater f
or one coffee is permanently stored.
‘Please select product:’ appears on the display.
E Y
ou can alter this setting at an
y time by repeating the above
procedure.
E The amount can be permanently adjusted to the cup size for
the products shown in the product selector too. To do this,
press and hold the Rotary Switch k until ‘Enough coffee?
Press butt
on.’ appears.
E Y
ou can also permanently set the amount fo
r all specialty
coffees, milk and hot water in programming mode (see Chap-
ter 4 ‘Permanent settings in programming mode – Product
settings’).
Permanently setting
amounts for the cup size
To Next Page
Loading...
Need help?
General
Weight and Dimensions
