EasyManuals Logo
Home>JVC>Camcorder>GR-DV3000

JVC GR-DV3000 User Manual

JVC GR-DV3000
96 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #74 background imageLoading...
Page #74 background image
74
EN
If, after following the steps in the chart below, the problem still exists, please consult your nearest JVC dealer.
The camcorder is a microcomputer-controlled device. External noise and interference (from a TV, a radio,
etc.) might prevent it from functioning properly. In such cases, first disconnect its power supply unit (battery
pack, AC Power Adapter/Battery Charger, etc.) and wait a few minutes; and then re-connect it and proceed
as usual from the beginning.
TROUBLESHOOTING
The power is not connected
properly.
The battery is dead.
The LCD monitor is not open fully
or the viewfinder is not pulled out
when recording.
The date/time is not set.
The built-in clock battery has run
out and the previously set date/time
has been erased.
For Tape Recording
The tapes erase protection tab is
set to SAVE.
The Power Switch is set to
or OFF.
The VIDEO/MEMORY Switch is set
to MEMORY.
•“TAPE END appears.
The cassette holder cover is open.
For Memory Card Recording
The VIDEO/MEMORY Switch is set
to VIDEO.
The camcorder is not getting power,
or some other malfunction exists.
The Power Switch is set to .
Focus is set to the Manual mode.
The recording was done in a dark
place, or the contrast was low.
The lens is dirty or covered with
condensation.
Connect the AC Power Adapter/
Charger securely ( pg. 9).
Replace the dead battery with a
fully charged one ( pg. 8, 9).
Open the LCD monitor fully or pull
out the viewfinder.
Set the date/time ( pg. 11).
Consult your nearest JVC dealer for
replacement.
Set the tapes erase protection tab
to REC ( pg. 12).
Set the Power Switch to or
( pg. 17).
Set the VIDEO/MEMORY Switch to
VIDEO.
Replace with new cassette
( pg. 12).
Close the cassette holder cover.
Set the VIDEO/MEMORY Switch to
MEMORY.
Turn the camcorders power off and
on again ( pg. 14).
Set the Power Switch to
( pg. 14).
Set Focus to the Auto mode
( pg. 24).
Clean the lens and check the focus
again ( pg. 80).
SYMPTOM POSSIBLE CAUSES CORRECTIVE ACTION
1 No power is supplied.
2 SET DATE/TIME! appears.
3 Recording cannot be
performed.
4 There is no picture.
5 Some functions are not
available using the MENU
wheel.
6 The focus does not adjust
automatically.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the JVC GR-DV3000 and is the answer not in the manual?

JVC GR-DV3000 Specifications

General IconGeneral
BrandJVC
ModelGR-DV3000
CategoryCamcorder
LanguageEnglish

Related product manuals