EN 63
TW
Digital Dubbing
It is also possible to copy recorded scenes from the camcorder onto other video unit equipped with a DV
connector. Since digital signal is sent, there is little if any image or sound deterioration.
NOTES:
●
You cannot use the battery pack installed in the
camcorder as the power supply since a digital
signal is output from the DV OUT connector only
when using the AC Power Adapter/Charger.
●
When using the camcorder for dubbing, be sure
to use it as a player. The camcorder's DV
connector is only for output.
●
If a blank portion is played back during dubbing,
an unusual image may be dubbed.
●
Even though the DV cable is connected correctly,
sometimes the image may not appear in step 3. If
the above occurs, turn off power and make
connections again.
1
●
The image with Fade/Wipe Effects and P.AE/
Effects is not output from the DV OUT connector.
Only the original playback image is output from
it.
1
CONFIRM POWER-OFF STATUS
Make sure the camcorder's power is off.
2
MAKE CONNECTIONS
Connect the camcorder to your video unit
equipped with a DV connector using the DV
cable (optional) as shown in the illustration.
3
START PLAYBACK
Press the Play button (
4
) to play back the
source tape.
4
START RECORDING
While watching the playback on the LCD
monitor, engage the DV connector-equipped
video unit's record mode from the spot on the
source tape you want to begin recording.
AC Power
Adapter/Charger
DC cord
Video unit equipped
with DV connector
RM-V711U
(provided)
To DV
connector
To DV OUT
connector
DV cable (optional)
PLAY
STOP
To AC outlet
Core filter
To DC IN jack
To DC OUT jack
To Next Page
Loading...
Need help?
General
