Error Messages and Actions
Warning
display on the LCD monitor and viewfinder screen, tally lamp indication and warning tone are as
follows according to the error status.
Memo :
0
This camera recorder makes use of a microcomputer. Noise interference from external sources may
prevent
it from functioning properly. When this occurs, turn off and on the power of the camera recorder
again.
Error Message Status Action
Turn Power Off Turn Back On
Later
System error.
* The
warning tone sounds and the
tally lamp blinks twice every
second.
Turn off the power, and turn it on
again.
If the error persists, please contact
the local dealers in your area.
Fan Stop Detected Please
Turn P.Off
0
The fan stopped running. Please contact the local dealers in
your area.
Fan Maintenance Required Usage time of the fan has exceeded
9000 hours.
Check the fan and replace
accordingly. For more details,
please contact the local dealers in
your area.
Memo :
0
You
can check the usage time of
the fan in [System] B [System
Information] B [Fan Hour].
(A P
114 [ Fan Hour ] )
Getting Overheated. Please
Turn Power Off.
0
The battery has exceeded the
specified temperature.
0
The power turns off
automatically after about 15
second.
0
Wait until the temperature drops
or replace the battery.
0
If the error persists, please
contact the local dealers in your
area.
Rec Inhibited [REC] button is pressed when the
write-protect switch of the SD card
is set.
Turn off the write-protect switch of
the SD card, or insert a recordable
SD card.
(A P
40 [SD Card] )
Lost Media Info *
0
Card
is removed while recording
is in progress.
0
Card is removed while
formatting is in progress.
0
Card is removed while restoring
is in progress.
0
Card is removed while adding
the OK mark.
0
Card is removed while writing a
setup file.
0
Card is removed while deleting a
clip.
(*: A, B)
Restore the card using this camera
recorder.
(A P43 [Restoring the SD Card] )
170
Error Messages and Actions
Others
To Next Page
Loading...
Need help?
General
