Special Recording
Besides the normal recording mode, four special
recording methods are available in this camera
recorder. They are Pre Rec, Clip Continuous,
Frame Rec and Interval Rec.
Select a mode from
[Main Menu] B [System] B
[Record Set] B [Rec Mode].
(A P116 [ Rec Mode ] )
Memo :
0
When [Main Menu]
B
[System]
B
[Record Set]
B
[Record Format]
B
[
W
Format] is set to “AVCHD”,
“Clip Continuous” cannot be selected.
(A P115 [
W
Format ] )
0
When [Main Menu]
B
[System]
B
[Record Set]
B
[Record Format]
B
[System] is set to “HD+Web”,
special recording cannot be selected
Pre Rec
0
By
setting the number of seconds in the [Pre Rec
Time], you can start recording video and audio
before actual recording starts based on the [Pre
Rec Time] setting.
0
When
starting actual recording while the camera
recorder is in Recording Standby (STBYP)
mode, you can start recording a few seconds
earlier based on the [Pre Rec Time] setting.
0
Using Pre Rec allows you to record a complete
event without missing the initial scenes even if
you start the recording late.
Memo :
0
Pre Rec Time can be set in
[Main Menu] B
[System] B [Record Set] B [Rec Mode] B [Pre
Rec Time].
The following values can be selected depending
on the setting of [Main Menu] B [System] B
[Record Set] B [Record Format] B [System].
0
When [System] is set to
“4K”:
Fixed at “5sec”
0
When [
System] is set to “HD” or “SD”:
“5sec”, “10sec” or “15sec”
(A P116
[ Pre Rec Time ] )
.
(Recording stops)
Press [REC]
(Recording starts)
Press [REC]
Recording starts a
number of seconds
earlier based on the
[Pre Rec Time] setting
(Recorded video and audio)
Completed Clip
1
Set [Rec Mode] to “Pre Rec”.
(A P
116 [ Rec Mode ] )
0
Set [Main Menu] B [System] B [Record
Set] B [Rec Mode] to “Pre Rec”.
0
The display changes (
“STBY” B “STBYP”).
2
Press the [REC] button to start recording in
Pre Rec mode.
0
The display changes (“STBYP” B
“RRECP”)
and the card slot status indicator
lights up in red.
0
Press the [REC] button again to pause
recording. The display changes (“RRECP”
B “STBYP”) and the card slot status
indicator lights up in green.
Caution :
0
When the interval between start and stop
recording is short, “STBYP” may not be
displayed immediately after recording is
complete.
“RRECP” B “STBYP”
(“STBY” blinks in red) B
“STBYP” is displayed.
0
When the SD card becomes full during
recording, recording stops and
“STOP” is
displayed.
0
In the following cases, video and audio before
the
specified Pre Rec time may not be recorded
even if recording starts.
0
Immediately after power on
0
Immediately after recording stops
0
Immediately after switching from Media
mode to Camera mode
0
Immediately after setting
[Rec Mode]
0
Immediately after the end of Clip Review
0
Immediately after changing file format
0
Immediately after changing video format
78
Special Recording
Shooting
To Next Page
Loading...
Need help?
General
