ND Filter Warning Display
In order to adjust the amount of light when you are
shooting
at a relatively bright location, the diameter
of the iris may become extremely small, causing
blurry effects to occur as a result.
This phenomenon is known as “small aperture
diffraction”. You can make appropriate use of ND
filters to prevent it from occurring.
This unit displays an ND filter warning when
necessary to prompt you to select an appropriate
ND filter.
1
Set [Main Menu] B [LCD/VF] B [Display
Settings
] B [ND Filter] to “On+Assist”.
(A
P107 [ ND Filter ] )
2
When the iris diameter becomes too small
while adjusting the light intensity, or when
an ND filter is used in a dimly-lit location,
the ND filter display starts blinking.
Adjusting the White
Balance
Adjust the white balance according to the color
temperature of the lighting. You can select the
adjustment mode according to the shooting
conditions.
As the color of the light (color temperature) varies
according to the light source, it is necessary to
readjust the white balance when the main light
source illuminating the subject changes.
.
Automatic White Balance Mode (FAW:
Fulltime Auto White balance)
1
Press and hold the [FULL AUTO] button to
set Full Auto mode to off.
2
Assign “FAW” (Full
Auto White Balance) to
one of the three [WHT.BAL B/A/PRST]
switches.
0
You can set the Full Auto White Balance
feature to either “A”, “B”, or “PRST”
in
[Camera Function] B [FAW].
(A P97 [ FAW ] )
0
If the position assigned with “FAW” is
selected using the [WHT BAL B/A/PRST
]
switch, the Automatic White Balance mode is
enabled and an appropriate white balance is
automatically adjusted according to the color
temperature of the lighting on the subject.
Caution :
0
The accuracy of
[FAW] is inferior to that of Auto
White Balance.
0
When the power of the camera recorder is
turned
on with the [FAW] mode selected, it takes
about 15 seconds for the colors to stabilize.
60
Setting the ND Filter
Shooting
To Next Page
Loading...
Need help?
General
