EasyManuals Logo
Home>JVC>Car Video System>KW-M565DBT

JVC KW-M565DBT User Manual

JVC KW-M565DBT
60 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #50 background imageLoading...
Page #50 background image
Troubleshooting
50
Troubleshooting
Problems and Solutions
If any trouble occurs, first check the following
table for possible problems.
NOTE
Some functions of this unit may be disabled by
some settings made on this unit.
What might seem to be a malfunction in your
unit may just be the result of slight misoperation
or miswiring.
Ñ About settings
Cannot set up the subwoofer.
Cannot set up subwoofer phase.
No output from the subwoofer.
Cannot set up the low pass lter.
Cannot set up the high pass lter.
Subwoofer is not set to on.
Set the subwoofer to on. See Speaker/ X’over
setup (P.39).
Ñ About audio operations
Radio reception is poor.
The car antenna is not extended.
Pull out the antenna all the way.
The antenna control wire is not connected.
Connect the wire correctly. See Connecting wires
to terminals (P.48).
Cannot select a folder.
The random play function is enabled.
Turn off the random function.
The sound skips when an audio le is being
played.
The recording condition is bad.
Record the file again or use another USB memory.
Ñ Other
The Touch Sensor Tone doesn’t sound.
The preout jack is being used.
The Touch Sensor Tone cannot be output from the
preout jack.
Error Messages
When you fail to operate the unit correctly, the
cause of the failure appears as the message on
the screen.
[No Device] (USB device)
The USB device is selected as a source although no
USB device is connected.
Change the source to any source other than USB.
Connect a USB device, and change the source to
USB again.
[Disconnected] (Bluetooth audio player)
The Bluetooth audio player is selected as a source
although no Bluetooth audio player is connected.
Change the source to any source other than
Bluetooth. Connect an Bluetooth audio player, and
change the source to Bluetooth again.
[No Media le]
The connected USB device contains no playable audio
file. Media was played that doesn’t have data recorded
that the unit can play.
See Playable Media and Files (P.51) and try
another USB device.
!B5H-0357-06_JVC_KWM_E_En.indb 50 2020/08/21 13:43

Other manuals for JVC KW-M565DBT

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the JVC KW-M565DBT and is the answer not in the manual?

JVC KW-M565DBT Specifications

General IconGeneral
AM band range531 - 1.611 kHz
FM band range87.5 - 108 MHz
LW band range153 - 279 kHz
Supported radio bandsAM, DAB+, FM, LW, MW
Radio Data System (RDS)Yes
Preset stations quantity20
DIN size2 DIN
Output power200 W
Product colorBlack
Disc types supported-
Audio output channels- channels
Equalizer bands quantity13
Maximum power per channel- W
USB port positionRear
Bluetooth profilesHFP, PBAP
USB ports quantity1
Bluetooth functionsAudiostreaming, Handsfree calling
Audio formats supportedAAC, FLAC, MP3, SBC, WAV, WMA, WMV
Video formats supportedH.264, MPEG1, MPEG2, MPEG4
Display diagonal6.8 \
Display resolution640 x 480 pixels
Weight and Dimensions IconWeight and Dimensions
Weight1300 g

Related product manuals