21
Figure 5.19 Figure 5.20
5.14 Starting and Driving
5.14.1 Make sure the driver's seat is installed properly.
5.14.2 Make sure the steering column has been secured properly.
5.14.3.Make sure the armrests have been returned to the proper down position.
5.14.4 Turn the ignition ON. If necessary, turn on the headlight and taillight.
5.14.5 Check the battery indicator and make sure there is enough power for your
trip(s). If you have any doubt about the remaining power, please charge the
battery before you depart.
5.14.6 Set the speed dial to the proper level.
5.14.7 Be sure the variable speed levers are in good condition.
5.14.8 Make sure the electromagnetic brake is in good working order.
5.14.9 Always make sure that your surroundings are safe to operate the scooter.
CAUTION
● Do not pull both variable speed levers simultaneously, since you might
not be able to control your scooter and may cause permanent damage.
● Do not turn the ignition OFF while driving, as this will lead to an abrupt
stop and possible injury.
● Do not set the speed dial on high while driving indoors.
● Do not adjust the speed dial while driving. A sudden change to the
highest speed may endanger you and cause failure to your scooter.
● Do not place magnetic devices near the control panel as this may affect
the operation of your scooter.
● Be careful while driving in heavy traffic and crowded areas.
● While reversing the vehicle be aware of people and objects behind you.
To Next Page
Loading...
Need help?
General
