23
6. BATTERIES AND CHARGER
6.1 Charging the Batteries
Before you attempt charging, ensure you read and understand the instruction
manual supplied with the battery charger, and you choose the correct input voltage
for battery charger.
6.2 Charge your batteries if any of the following conditions occur
6.2.1 If you have used your scooter for more than an hour continuously. We
recommend you charge the batteries after your use.
6.2.2 You've used more than one third of the total charge.
6.2.3 When you haven't used the scooter for more than two weeks.
6.2.4 If the current charge is not enough to reach your final destination.
6.3 Be sure to precisely follow the procedures listed below
6.3.1 Turn the scooter OFF and remove the key.
6.3.2 Connect the charger's cord to a power outlet.
6.3.3 Open the charging socket cap on the steering column.Then connect the
charger's round plug to the charging socket. (See Figure 6.1)
6.3.4 Turn on the charger with the power switch.
6.3.5 Both the charger's red and orange LED will light up as soon as the charging
starts. The charging time is at least 6 hours, but it could be as long as 10 hours,
depending on the status of the batteries and the temperature.
6.3.6 The orange LED will change to green when the charging is completed.
6.3.7 Turn off the charger, disconnect the cord and pull out the round plug from the
charging socket.
Charger
Figure 6.1
To Next Page
Loading...
Need help?
General
