35
● Do not directly spray water on your scooter to wash it as this could lead
to a malfunction in the electric system.
● Do not use gasoline, solvents or other abrasive solutions; the casing
may become deformed or damaged.
WARNING
● After ANY adjustments, repair or service and BEFORE use, make sure
that all hardware is tightened securely, otherwise injury or damage may
occur.
7.5 Suggested Maintenance Procedures
7.5.1 Before using the powered scooter, make sure all nuts and bolts are tight.
Check all parts for damage or wear and have a qualified technician replace it if
necessary. Check all parts for proper adjustment.
7.5.2 Ensure that the batteries are properly maintained and charged as required.
7.5.3 Inspect the brake for proper operation
7.5.4 The wheels and tires should be checked periodically for cracks and wear, and
should be replaced by a qualified technician.
7.5.5 Regularly check for loose nuts and/or bolts in the front and rear wheels. If they
are loose, have them adjusted by a qualified technician.
7.5.6 Clean the dirt, dust and grease from exposed components.
7.5.7 A qualified technician can be found with an authorized distributor/dealer.
7.6 Transporting and Storing
Make sure the vehicle is stored with the seat set to the forward position, with the
ignition turned OFF and the key removed
SUGGESTION
● Please store the scooter in a location where it is out of direct sunlight,
rain and dew. When stored for a long time, please charge the batteries
to full and then disconnect the battery terminals. For more details,
consult your KARMA Scooter dealer.
7.7 Disassembling the Scooter
7.7.1 NOTE: To re-assemble the scooter, reverse the following procedure.
7.7.1.1 Remove the front basket, if applicable.
7.7.1.2 Fold the backrest down.
To Next Page
Loading...
Need help?
General
