In this section:
Topic Page
Front and rear panel familiarization................................................. 1-2
Front panel summaries.................................................................. 1-2
Rear panel summaries .................................................................. 1-2
Model 2601A/2602A and Model 2611A/2612A rear panels........... 1-5
Model 2635A/2636A rear panels................................................... 1-7
What are the source-measure capabilities? .................................... 1-9
What are the source-measure capabilities?.................................... 1-9
Model 2601A and Model 2602A .................................................... 1-9
Model 2611A and Model 2612A .................................................... 1-9
Model 2635A and Model 2636A .................................................... 1-9
How do I power-up the instrument?................................................. 1-10
Connect to line power.................................................................... 1-10
Turn on power ............................................................................... 1-10
Set line frequency.......................................................................... 1-10
How do I make measurements? ....................................................... 1-11
Connect the DUT........................................................................... 1-11
Select source and set source level................................................ 1-11
Set compliance limit ...................................................................... 1-11
Select measurement function and range....................................... 1-12
Turn output on ............................................................................... 1-12
Make measurements..................................................................... 1-12
Turn output off ............................................................................... 1-12
How do I use the reading buffer?..................................................... 1-15
Connecting the device under test (DUT) ....................................... 1-15
Set up source and measure functions........................................... 1-15
Configuring the reading buffer....................................................... 1-15
Turn on the output ......................................................................... 1-16
Storing reading buffers .................................................................. 1-16
Turn off the output ......................................................................... 1-16
Recalling readings......................................................................... 1-16
Section 1
Front and Rear Panel Operation
To Next Page
Loading...
Need help?
General
