Sew a Button
13
Thread tension
3_o6
\
F Satin stlteh
foot
Drop teed lever
Drop the feed dogs. (see p. 32).
1. Match the button holes to the horizontal slot on
the presser foot.
2. Lower the toot to hold the button in place.
3, Turn the hand wheel by hand until the needle
point _s_ust above the button.
4. Press the stitch width button (+ or --} so the
needle will enter the left hole of the button,
Draw thread to
reverse side ot
tabric
5. Turn the hand wheel so the needle will enter the
right hole of the button. Readjust the stitch
width if necessary.
6. Stitch several times.
7. After you finish sewing, cut thethread but leave
3 to 4 inches of thread at the button.
8. Draw the thread to the reverse side of the fabric
and knot the threads.
When sewing the button =scompleted, razse the feed
dogs tor normal sewing,
To Next Page
Loading...
Need help?
General
