Set Up the Machine
e Plug in the Machine and Switch on the Power
(_ Power supply
Power
switch
supply
ppfy
cord
Foot control
Machine
sockets
Machine
plug
I_) Foot control
plug
Before connecting the power cord, make sure the voltage and frequency shown
on the machine conform to your electrica_ power.
Turn off the power switch, and insert the foot control plug (_ machine plug
(_ and power supply plug (_) in thts order.
For Your Safetv
1. While in operatLon, always keep your eye on the sewing area, and do not
touch any moving parts such as the thread take-up lever, balance wheel or
needle.
2, Always turn off the power switch, and unplug from the power supply:
• When leaving the machine unattended.
When attaching or removing parts.
• When cleaningthe machine.
3. Do not place anything on the foot control, except in use.
ACHINEF(
[ 0-4 Foot^)
Power switch
f,
Sewing light
When the power switch is turned on, the straight stitch is set on liquid crystal
display automatically.
Store the power supply cord
L 15cm_ 16cm =i
I
Power supply cord can be stored in extension table as shown,
To Next Page
Loading...
Need help?
General
