EasyManuals Logo

Kenwood DM-SG7 User Manual

Kenwood DM-SG7
52 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #2 background imageLoading...
Page #2 background image
DM-SG7(EN)
2
Before applying power
Before applying power
Caution : Read this page carefully to ensure safe operation.
Units are designed for operation as follows.
U.S.A. and Canada ................................................................... AC 120 V only
Australia .................................................................................... AC 240 V only
The marking is located on the rear panel and says that the compo-
nent uses laser beams that have been classified as Class 1. It means
that the unit is utilizing laser beams that are of a weaker class. There
is no danger of hazardous radiation outside the unit.
CLASS 1
LASER PRODUCT
The marking of products using lasers
(Except for some areas)
For the United Kingdom
Factory fitted moulded mains plug
1.The mains plug contains a fuse. For replacement, use only a 13-
Amp ASTA-approved (BS1362) fuse.
2.The fuse cover must be refitted when replacing the fuse in the
moulded plug.
3.Do not cut off the mains plug from this equipment. If the plug
fitted is not suitable for the power points in your home or the cable
is too short to reach a power point, then obtain an appropriate
safety approved extension lead or adapter, or consult your dealer.
If nonetheless the mains plug is cut off, remove the fuse and dis-
pose of the plug immediately, to avoid a possible shock hazard by
inadvertent connection to the mains supply.
IMPORTANT: The wires in the mains lead are coloured in accord-
ance with the following code:
Blue : Neutral
Brown : Live
Do not connect those leads to the earth terminal of a three-pin plug.
Europe and U.K.........................................................................AC 230 V only
China and Russia ..................................................................... AC 220 V only
*Other countries ................................ AC 110-120 / 220-240 V switchable
Safety precautions
WARNING : TO PREVENT FIRE OR ELECTRIC SHOCK, DO NOT EXPOSE THIS APPLIANCE TO
RAIN OR MOISTURE.
CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE COVER
(OR BACK). NO USER-SERVICEABLE PARTS INSIDE. REFER SERVICING TO QUALI-
FIED SERVICE PERSONNEL.
RISK OF ELECTRIC SHOCK
DO NOT OPEN
THE LIGHTNING FLASH WITH ARROWHEAD SYMBOL, WITHIN AN EQUILATERAL TRIANGLE, IS INTENDED
TO ALERT THE USER TO THE PRESENCE OF UNINSULATED “DANGEROUS VOLTAGE” WITHIN THE
PRODUCT’S ENCLOSURE THAT MAY BE OF SUFFICIENT MAGNITUDE TO CONSTITUTE A RISK OF ELEC-
TRIC SHOCK TO PERSONS.
THE EXCLAMATION POINT WITHIN AN EQUILATERAL TRIANGLE IS INTENDED TO ALERT THE USER TO
THE PRESENCE OF IMPORTANT OPERATING AND MAINTENANCE (SERVICING) INSTRUCTIONS IN THE
LITERATURE ACCOMPANYING THE APPLIANCE.
CAUTION

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Kenwood DM-SG7 and is the answer not in the manual?

Kenwood DM-SG7 Specifications

System and Audio IconSystem and Audio
systemMinidisc digital audio system
laserSemiconductor laser
recording methodField modulation overwrite method
audio compressionATRAC (Adaptive TRansform Acoustic Coding)
playing rotationApprox. 400 rpm ~ 900 rpm (CLV)
D/A conversion1 Bit
oversampling128 fs (5644.8 kHz)
A/D conversion methodSigma-delta method
sampling frequency44.1 kHz
Digital Audio Performance IconDigital Audio Performance
frequency response (playback mode)8 Hz ~ 20 kHz, ± 1 dB
signal to noise ratio (playback mode)More than 92 dB
dynamic range (playback mode)More than 90 dB
total harmonic distortion (1 kHz, playback mode)Less than 0.007 %
channel separation (1 kHz, playback mode)More than 85 dB
wow & flutterLess than unmeasurable limit
Inputs and Outputs IconInputs and Outputs
analog input sensitivity / input impedance300 mV / 70 kΩ
analog output level / load impedance1.2 V / 3.2 kΩ
digital input, optical (wave length 660 nm)- 15 dBm ~ - 21 dBm
General Specifications IconGeneral Specifications
power consumption14 W
dimensions (width)200 mm (7 - 7 / 8")
dimensions (height)77 mm (3 - 1 / 16")
dimensions (depth)247 mm (9 - 3 / 4")
weight (net)2.1 kg (4.6 lb)

Related product manuals