Maintenance
947
Light bulbs
A skilled technician should check or
repair the stop and tail lamp (LED),
for it may damage related parts of
the vehicle.
Replacing reversing lamp (bulb
type)
1. Remove the plastic tabs with a
flat-tip screw driver.
2. Loosen the plastic retaining
screws and remove the under
panel cover.
3. Disconnect the rear back up lamp
connector (A).
4. Remove the socket (A) from the
assembly by turning the socket
counterclockwise until the tabs on
the socket align with the slots on
the assembly.
5. Remove the bulb from the socket
by pressing it in and rotating it
counterclockwise until the tabs on
the bulb align with the slots in the
socket. Pull the bulb out of the
socket.
6. Insert a new bulb by inserting it
into the socket and rotating it
until it locks into place.
7. Install the socket in the assembly
by aligning the tabs on the socket
with the slots in the assembly.
Push the socket into the assem
-
bly and turn the socket clockwise.
8. Connect the rear back up lamp
connector.
9. Tighten the plastic retaining
screws.
10.Install the plastic tabs and the
under panel cover.
To Next Page
Loading...
Need help?
General
